TEC-HRO rapid sight elevation

TEC-HRO rapid, sight raiser block, sight elevation

NEW The revolution in the sector of the increases of line of sight!

€158.82
Tax included Shipping excluded
 Last items in stock

TEC-HRO rapid - the new universal Visierlinienerhönung!

 

TEC-HRO rapid is a never-before-seen type of sight raiser!

Short video

  • Height adjustment within seconds 
  • After initial installation There is no tool more required! (Protection of the Patent Office)
  • can be increased by 12mm (basic level) in 2, 5 mm increments to 39, 5 mm grid! (Protection of the Patent Office)
  • A grid with scale shows the height and is used for the Reproduction for each discipline
  • Diopter - and grain increase are According to rays so made, that when adjusting (E.g. by standing on lying) the rear sight is not or hardly must be corrected! (Protection of the Patent Office)
  • This requires only the three position shooter a diopter, a sight elevation and a grain tunnel What prevents also likelihood of confusion (in the final) and right Saves money!
  • saves valuable time during the rebuild -from one to the next discipline, which is in particular in the new Dreistellungs-final mode of extreme importance more time for test firings to have!
  • the fact that always the same sight elevation is used, also the shot image remains the same (only slight changes of the weight in the mouth for example through exchange of sight elevation, can worsen the shot image!)
  • Weight 120 g (grain boost 50 g, Dioptererhöhung 70 g thus part approx. 20 g more than a "normal" sight elevation)
 
All in all a product, what time, money and space (because no 3 diopter, 3 increases in sight, 3 grain tunnel... more required) but also unnecessary excitement and energy saving, which has given the gunners in the competition to other reserves!
Here is a quick guide: 

 

When first firing it is advisable to adjust the height suitable for the best and to inject the rear sight on it.

A different altitude, selects one then for kneeling or standing this is the grain and the diopter on same height to set. The side scale can be used for orientation and to the reproduction.

Caution: when adjusting is sure that one Prism plates easily "bounce while tightening the knurled screws front and rear", so that when tightening the knurled screw the parts properly Center. Otherwise, it may happen that the shots do not equal "land immediately close to the Centre".

Here some tact may be required initially.

Also a different warp between the attacks may be the cause that the results do not close to the Centre "land after height adjustment". 

TEC-HRO
0199
0.50 kg

Reviews

No customer reviews for the moment.

Write your review

  • Required fields
Required fields
Required fields